How to Load a Map or DLC on Your ARK Server
This guide covers loading any official ARK: Survival Evolved DLC map (Ragnarok, Fjordur, Genesis, and the rest) or a custom Steam Workshop map. The fastest route is the predefined command line; a custom command line gives you more control. Before switching, run Update/Repair Server Files so the map content is present, and see how to add mods if your map needs mods.
Before you start: Changing maps starts a fresh world. Your current map's save is kept and is there again if you switch back. To preserve progress, create a backup first.
Use a predefined map (easiest)
- Log into the game panel and open your ARK service.
- Run Update/Repair Server Files if you have not recently.
- Open the Command Line Manager.
- Pick the map you want from the predefined command lines, then click Select on the right.
- The server restarts on the new map.
Use a custom command line
For full control over parameters, set the map yourself:
- In the Command Line Manager, open the Custom Commandlines tab and click New.
- In the Server Map field, enter the map's code from the table below. For custom Workshop maps, use the map's official name from its Steam page instead.
- Set any other parameters, save, and click Select.
Map codes
Use these in the Server Map field of a custom command line. The predefined dropdown sets them for you automatically.
| Map | Server Map code |
|---|---|
| The Island | TheIsland |
| The Center | TheCenter |
| Scorched Earth | ScorchedEarth_P |
| Aberration | Aberration_P |
| Extinction | Extinction |
| Genesis Part 1 | Genesis |
| Genesis Part 2 | Gen2 |
| Ragnarok | Ragnarok |
| Valguero | Valguero_P |
| Crystal Isles | CrystalIsles |
| Lost Island | LostIsland |
| Fjordur | Fjordur |
| Aquatica | Aquatica |
Note: Genesis Part 2 needs more than 8 GB of RAM, so confirm your plan has the memory before loading it. Aquatica is a mod map and also requires its Steam Workshop mod installed.
Custom Workshop maps
- Find a map in the ARK Steam Workshop and install it like any other mod, covered in how to add mods.
- On the map's Steam page, find its official map name (the page lists the exact name to use).
- Enter that name in the Server Map field of a custom command line, save, and click Select.
Troubleshooting
If a custom map will not load (CPU at 0% while the player count shows correctly):
- Stop the server and run Update/Repair Server Files. Wait for it to finish.
- Recheck that the map name matches the official name on the Steam Workshop page exactly.
If an official map fails after content was deleted, force a file validation to restore it.